Home › Guides

When should you replace your tires?

When should you replace your tires?

There are three separate reasons to replace a tire: worn tread, age, and damage. A tire can fail on any one of them, even if the other two look fine.

A tire with deep tread can be too old. A new-looking tire can have damage that makes it unsafe. Check all three.

1. Tread depth: the legal line and the safe line

Tread is the grooved rubber that touches the road. As it wears, the grooves get shallow. Shallow grooves cannot move water out of the way, and grip falls — first in rain, then everywhere.

2/32 of an inch is the legal minimum in most states. At that depth, the tire is worn out by law and by any honest measure. Driving below it is not saving money. It is borrowing against your safety.

4/32 of an inch is the practical line for rain. At 4/32, wet grip is already much weaker than when the tire was new. If you drive often in rain, or at highway speed in rain, plan to replace at 4/32 rather than waiting for 2/32.

Winter is stricter still. Snow traction needs even more tread. A tire that is fine for a dry summer may be poor in snow well before it reaches 2/32.

The penny test

You do not need a gauge to get a rough answer, though a simple tread depth gauge costs a few dollars and is more precise.

Take a penny and insert it into a tread groove, with Lincoln's head pointing down into the tire.

Check several grooves, and check more than one spot around the tire. Wear is often uneven. The shallowest spot is the one that counts.

Many tires also have wear bars — small raised bars of rubber across the grooves. When the tread wears down level with those bars, the tire is at 2/32. That is the end, not a warning to start thinking about it.

Wear patterns tell a story

If one edge wears faster than the other, or the center wears faster than the edges, something else is wrong. Common causes are misalignment and wrong air pressure.

Replacing the tires without fixing the cause just wears out the new set the same way. Ask the shop to check alignment and pressure habits when wear is uneven.

2. Age: rubber gets old even if you do not drive

Tires age whether they roll or sit. Heat, sunlight, and time harden the rubber and weaken it from within. A spare that has never touched the road can still be too old to trust.

The common guidance is this: have tires inspected closely from about six years, and replace them by ten years at the latest, regardless of tread. Vehicle and tire makers vary a little in their exact wording, but that six-to-ten-year window is the standard advice. When in doubt, the earlier end is the safer end, especially in hot climates.

How to read the age: the DOT code

Look on the sidewall for the letters DOT, followed by a string of letters and numbers. The last four digits are the date code.

So 2321 means the tire was made in the 23rd week of 2021. 0519 means the 5th week of 2019.

The code may only be printed in full on one side of the tire. If you cannot find four digits, check the other sidewall, or ask a shop to read it for you.

Count age from the date the tire was made, not the date you bought it. A tire can sit in a warehouse before it is sold.

3. Damage: replace now, do not monitor it

Some damage ends the discussion. Replace the tire if you find:

If you are unsure whether damage is serious, have it inspected before a long trip, not after. A tire shop can dismount the tire and look inside. Surface guesses miss internal damage.

So, in miles and in years

There is no single mileage that fits every tire. Some tires carry a mileage warranty of 40,000 miles, others 70,000 or more, and real life depends on your roads, your driving, your pressure, and your rotation habits.

Use both clocks:

Whichever clock runs out first wins.

Tires are the only part of your car that touches the road. When the tread, the date, or the sidewall tells you it is time, believe it.

Next step: put it into practice — find the 3 tires for your car, or read how we recommend.